How we perform an Air Duct Cleaning.
Only AMERICAN AIR DUCT CLEANERS gives you a clear step by step description of our air duct cleaning process.
Step 1: The technician will cycle your air handler to ensure that it is working properly. If any abnormalities are discovered, the technician will be sure to inform the customer.
Step 2: The TurboJet negative air machine is attached to the system. The vacuum hose is securely installed into the trunk line to create a centralized vacuum.

Step 3: we will remove wall, ceiling and Floor registers, Wash Registers with Dynamite cleaner and rinse.

Step 4: All registers are blocked off to create a sound vacuum on the entire side of the air duct system to be cleaned.

Back to Top
Step 5: We proceed to completely clean the supply trunk line with a The Cobra Power Brush that will aggressively remove duct debris. The Sidewinder Air Powered tool will remove duct debris more gently to agitate all four walls of interior trunk line and all the contamination is then removed by the power vacuum hose.

Step 6: We will decontaminate the cleaned ducts by fogging Sporicidin, Soot set sealant, and Odor Kill Deodorizer.

Back to Top
Step 7: We begin to vacuum the interior surfaces of the Furnace/Air Conditioner, clean the cooling coils with a HEPA vacuum and a coil cleaner. we will also clean the Blower unit. If air conditioning is present and the customer wishes to pay us to clean their evaporator coil (indoor coil), the technician will gently air wash the outside and inside of the evaporator coil fins to dislodge the common dust mat found on the fin surfaces. Matted coils are a haven for nasty microbial's and can also cause your air conditioner to run less efficiently (in fact an average of 20% less efficiently, according to ASRAE). The condensate drain pan and drain is also air washed. Upon completion of source removal and EPA registered biodegradable, earth friendly evaporator foam cleaner is applied to thoroughly clean through the fins and will sanitize and deodorize the coil. *NOTE: AMERICAN AIR DUCT CLEANERS encourages severe sinus and respiratory sufferers to inform us of their condition pertaining to cleaning substances. Just because 99.99% of people are o.k around a predominantly inert substance, doesn't mean that everyone is. Through good communication between AMERICAN AIR DUCT CLEANERS and customer we can adapt and adjust cleaning procedures to cater to even the most sensitive needs.


Back to Top
Step 8: The technician will reassemble your furnace and install reusable clean out doors. If the homeowner is using a disposable filter, the new filter will be installed. Ask the technician about our electrostatic filters. for more information click here.

Step 9: The air handler will be turned on and the technician will make sure that the air handler is cycling properly.
Step 10: All working areas are cleaned and cleaning equipment is removed from the home or job site- Leaving you with nothing to remember us by except clean, fresh air.
ABOUT US - PRODUCTS - PROCEDURE - SERVICES - CONTACTS